For some reason, I'm suddenly getting the problem where I take my world into Edit In Game and there is a white fog that I can't see through at the View Map/Edit Town level. I've been working on this world for a while, but this is the first time I've experienced it. I read that if I put the LOD bar in camera settings all the way to the right, it will fix it. I've tried this, saved, then loaded in Edit In Game on three occasions with no success. The thing is that when I leave Edit In Game and return to CAW, the LOD setting is back to default (one from the left). Does anyone know how I could fix this?
0
Comments
It's usually caused when you enter EIG with the camera view too high from ground level.
Save/Quit in EIG then lower the camera to ground level and try EIG again. Or maybe restarting CAW then keep the camera view very low and start EIG.
Good luck
Do you have any other suggestions? Do you know if the problem may be my world or CAW? Again, thank you for the reply.
http://ts3cc.forumotion.ca/t24-caw-fog-invisible-water-workaround-by-wyndhane
Once done the Fog was gone when I went back into CAW and EIG. It still works fine now and I have not had the issue since so I suggest you try it.
In CAW:
1. Go to view tab and select time of day
2. Change cloudiness level over in the window that pops up to the right
3. Save world
4. Close CAW
5. Restart CAW for changes to apply
Once you re-open edit in game mode problem should be fixed